HiVis
12 items

Ladder Inspection Checklist

A pre-use ladder inspection checklist for stepladders and extension ladders, based on OSHA 1926.1053.

How often
Before each use and after any event that could damage the ladder
Reference
OSHA 29 CFR 1926.1053(b)(15)

General condition

  • Label with duty rating is present and readable☐ Pass☐ Fail☐ N/A
  • No cracks, splits or bends in rails☐ Pass☐ Fail☐ N/A
  • Rungs and steps are tight, undamaged and free of oil or mud☐ Pass☐ Fail☐ N/A
  • No corrosion on metal parts☐ Pass☐ Fail☐ N/A

Hardware

  • Feet and slip-resistant pads are in place☐ Pass☐ Fail☐ N/A
  • Spreader bars lock fully (stepladders)☐ Pass☐ Fail☐ N/A
  • Rung locks and pulley work (extension ladders)☐ Pass☐ Fail☐ N/A
  • Rope is not frayed (extension ladders)☐ Pass☐ Fail☐ N/A

Setup

  • Ladder is the right height and duty rating for the task☐ Pass☐ Fail☐ N/A
  • Base is on firm, level ground☐ Pass☐ Fail☐ N/A
  • Extension ladder set at 4:1 and extends 3 ft above landing☐ Pass☐ Fail☐ N/A
  • Fiberglass ladder used near electrical work☐ Pass☐ Fail☐ N/A

Frequently asked questions

How often should ladders be inspected?

OSHA requires a competent person to inspect ladders periodically and after any occurrence that could cause damage. Most contractors also do a quick check before each use.

What do I do with a damaged ladder?

Tag it 'Do not use' and remove it from service until it is repaired or destroyed. Do not leave it on site where someone may pick it up.

Related